Installing A Secondary Hdd Or Media Card Reader Into A Z210 Sff - HP Z210 Series User Manual

7.
Align the guide screws with the slots on the chassis drive cage, press the hard drive down into the
bay, then slide it back until it stops and locks in place.
Figure 9-10
8.
Rotate the drive cage and the power supply down to their normal positions.
9. Replace all components that were removed in preparation for component installation.

Installing a secondary HDD or media card reader into a Z210 SFF

You can install an 8.89 cm (3.5 in) hard drive underneath the 13.3 cm (5.25 in) optical drive. A
media card reader can also be installed at this location. If an optical drive is present, you must remove
it to install the hard drive.
To install a hard drive or media card in the drive cage:
1.
Follow the procedures described in
the workstation for component installation.
2.
Remove the front bezel.
3.
Remove the optical disk drive if it is present. (See
Workstation on page
ENWW
Installing the hard drive (drive carrier shown)
Preparing for component installation on page 34
56.)
Installing an optical drive in an HP Z210 SFF
Installing a hard disk drive
to prepare
51