HP Z210 Series User Manual page 62

4.
Align the screws with the grooves in the drive bay and gently slide the drive into the casing. Slide
the drive completely in until it snaps into place.
CAUTION:
the drive to see if it can be easily disengaged. Failure to properly secure the drive can damage
the drive when moving the workstation.
Figure 10-2
5.
Connect the power and data cables to the optical disk drive and system board as shown in the
following figure. Refer to the side access panel service label for the location of the SATA
connectors. Connect the data cable in the next available connector.
Figure 10-3
6.
Replace all components that were removed in preparation for component installation.
54 Chapter 10 Installing optical disk drives
Verify that the optical disk drive is secure in the workstation chassis by pulling on
Inserting the ODD into the casing
Connecting ODD power and data cables
ENWW