Removing And Installing An Optane Memory Module - HP EliteDesk 880 G4 TWR Maintenance And Service Manual

6. To remove an M.2 SSD card, remove the screw that secures the card (1), lift the end of the card up (2),
and then slide the card out of the system board connector (3).
7. To install an M.2 SSD card, slide the pins on the card into the system board connector while holding the
card at approximately a 30° angle (1). Press the other end of the card down (2), and then secure the card
with the screw (3).
8. Rotate the drive cage down (see
9. Connect the power and data cables to the rear of the drives in the hard drive cage.
10. Reassemble the computer.

Removing and installing an Optane memory module

IMPORTANT:
replacing the module, be sure to install the new module in the same connector as the old module.
Drive cage on page
An Optane memory module can be installed in either M.2 connector on the system board. If
28)
Drives 45