HP Xw460c - ProLiant - Blade Workstation User Manual page 73

Starting the Sender on Linux
The Linux sender is started by the "rge" X server extension whose configuration is described in the previous
section. The Sender cannot be started manually. Proper configuration and startup of the Sender can be verified
by examining the X server log file (Xorg.0.log). The log file will show that the extension is loaded, and that the
extension has started the Sender:
Log file content should be like:
(II) LoadModule: "rge"
(II) Loading /usr/lib64/xorg/modules/extensions/librge.so
.
.
.
(RG) 10:29:52.654 HP Remote Graphics extension. Build date : Jul 15 2009
(RG) 10:29:53.002 Listening for RG connections at /var/opt/hpremote/rgsender/sockets/rgsender-rge:0
(RG) 10:29:53.631 Started rgsender process PID = 5780
END of log file example.
The rgsender.sh command has two options that can be executed from the command line. The rgsender.sh
command does not start the Sender if either of these options are used.
The functionality of each option is as follows:
[-v | -ver | -version]—Displays the Sender version information.
[-h | -help | -?]—Displays the rgsender.sh command line options that are listed on this page.
Uninstalling the Sender on Linux
To uninstall the RGS Sender on Linux, perform the following steps:
1. Log in as root.
2. If the default install.sh was used, then the following command should report some variation of the following
packages:
# rpm -qa | grep -i rgsender
rgsender_linux_64-5.1.0-1
rgsender_config_64-5.1.0-1
To remove the rgsender package (and corresponding configuration rpm if used), execute the command:
3.
rpm -e --allmatches rgsender_linux_64 rgsender_config_64
4. If the rgsender_config_64-*.rpm was installed, it must be removed first (or together as demonstrated
above) before removing the rgsender_linux_64-*.rpm package. This resolves dependencies between
the packages, and undoes the previous customizations performed by this rpm. If you are upgrading your
system from a previous version of RGS, it is suggested that you remove both packages, and then apply the
new software rpms for supported results.
Installing RGS 73