HP Xw460c - ProLiant - Blade Workstation User Manual page 182

Connection denied! The
iLO remote console is
enabled.
Unable to connect to
Sender:
The Receiver was unable
to resolve the specified
hostname or IP Address.
Verify that you entered the
value correctly.
Unable to connect to
Sender:
The Receiver resolved the
specified hostname or IP
address, but cannot
connect to the Sender.
Verify that the system is
accessible on your
network and that the
Remote Graphics Sender
service has been started
and is listening on a
pubic IP address and is
not blocked by a firewall.
The iLO remote console is enabled on the HP Blade Workstation. The
Blade must be configured in User Mode before connections are
allowed.
This is usually indicative of a DNS error.
The Receiver was able to look up and resolve the specified hostname
or IP address. However, the Receiver was unable to establish a
connection to the Sender. There are several possibilities such as the
Sender is not installed, the Sender is not running, the Sender is listening
on the wrong network interface, or a firewall is blocking the Sender.
RGS error messages 182