HP Visualize J5000 - Workstation Manual page 47

2. Insert and tighten the four T-15 screws.
3. Connect the two cables:
• Push the backplane power cable into the connector at the upper right side of the
hard disk backplane board.
• Push the SCSI ribbon cable into the connector at the bottom of the hard disk
backplane board. Make sure that it is seated all the way into the connector.
CAUTION Place both cables behind the retainer clips in the chassis wall. This will clear
the rails for the power supply and ensure that the cables are not cut when the
power supply is reinstalled.
Chapter 2
Parts Removal and Replacement
Removing and Replacing the Hard Disk Backplane Board
47