HP Visualize J5000 - Workstation Manual page 44

Parts Removal and Replacement
Removing and Replacing the I/O Board
Figure 2-42. Back View of the Workstation
T-15 Torx Screws
4. Facing the opened workstation, move any cables away from the I/O board.
CAUTION To avoid damaging system components with electrostatic discharge (static
electricity), make sure your grounding strap is securely connected to your
wrist and to the bare metal of the workstation.
5. Grasping the I/O board with both hands, slide it toward the front of the workstation and
pull it off of its ten keyhole standoffs. Place it on the conductive sheeting.
Replacing the I/O Board
1. Align the I/O board with the ten keyhole standoffs on the chassis wall, making sure the
keyhole standoffs are aligned properly. Slide the board toward the back of the
workstation to lock it into place.
2. Replace the two T-15 Torx screws that secure the I/O board to the rear wall of the
chassis as shown above. You may have to hold the I/O board in place while replacing the
screws.
44 Chapter 2