HP Tc2100 - Server - 128 MB RAM Installation Manual page 90

Appendix A
Table A-2. HP Server Hardware Specifications
This HP Server supports Intel Celeron or Intel Pentium III
Processors
processors (system board automatically detects processor FSB
and changes accordingly):
• Intel Celeron - 850 MHz and above with 100 MHz FSB
• Intel Pentium III - 1.13 GHz and above with 133MHz FSB
Chipset
VIA Pro133T chip set with 33 MHz PCI and 133 MHz FSB
speed support
Memory Supports up to three SDRAM DIMMS for a maximum total of
1.5 GB. Supported DIMM sizes and types: 128MB, 256MB,
and 512 MB registered, 3.3 volts, 72 bits wide, ECC single-bit
correcting, multi-bit detecting.
Video Embedded ATI Rage XL chip video with 4MB SDRAM
Supports up to 1600x1200, @ 65K colors. Refer to Table A-5,
"Video Display Modes" for more details.
SCSI
SCSI model only; Single Channel Ultra-160 LVDs AHA
29160LP SCSI Adaptec board at 160 MB/s transfer rate with
two 68-pin connectors
IDE Embedded Enhanced-IDE 33/66/100 dual channel controller
LAN Embedded Intel 82559 10/100 Fast Ethernet Controller
PCI Bus Five full-length 32-bit PCI slots at 33 MHz and 5 volts (P1 slot
occupied by SCSI Controller board for SCSI model)
I/O
Two Serial ports and one bi-directional parallel port with
ECP/EPP high-speed support; PS/2 style mouse and keyboard
connectors; USB support for printers, external modems, USB
hubs, keyboard, and mouse, but these features are NOS
dependent
CD-ROM Bundled CD-ROM drive; IDE interface; 48x speed or faster
84
and Integrated 128K L2 Cache on processor
and Integrated 512K L2 cache on processor
Specifications