HP Rx2620-2 - Integrity - 0 MB RAM Manual page 93

Options
The parmodify command supports the following command-line options.
Option
-pPartitionNumber
-a cell:[celltype]:[use_on_next_boot]
:[failure_usage][:clm]
-m cell:[celltype]:[use_on_next_boot]
:[failure_usage][:clm]
-I IPaddress
-r cell
-d cell
Description
Specifies the nPartition to be modified. PartitionNumber specifies the
unique number (integer) assigned to the nPartition.
The -p option is required.
You must also specify any one or more of the following options.
Specifies the cells to be added to the nPartition.
The only valid type value is:
• base: Base cell (the default)
The valid use_on_next_boot values for cells are:
• y: Participate in reboot (the default)
• n: Do not participate in reboot.
The only valid failure_usage value is:
• ri: Reactivate with memory interleave (the default). Specifies to
integrate the cell into the nPartition as normally occurs.
The clm value specifies the amount of memory that will be configured
as cell local memory for the cell. You can specify the clm value in either
of two forms: percentage or absolute amount of memory. The default
is 0 (no cell local memory).
• Percentage cell-local memory (CLM): The percent number can be
any number in the range 0–100 with a suffix of %.This number is
rounded to 12.5%, 25%, 37.5%, 50%, 62.5%, 75%, 87.5% or 100%. If
the cell contains less than 4 GBytes of memory, then the percentage
is rounded to 25%, 50%, 75% or 100%. Percentages are rounded up
or down to the nearest value, but are not rounded up to 100%.
• Absolute CLM specification (the default): The absolute number is
interpreted as an absolute number of gigabytes of memory and can
optionally have a suffix of GB. As needed, an absolute CLM
specification is rounded up to the nearest 0.5 GBytes.
If the clm value is rounded, the command reports the final value used.
Modifies attributes of a cell already assigned to the nPartition.
See the -a option descriptions for details on the type, use_on_next_boot,
failure_usage, and clm cell attributes.
Specifies the IP address that can be used by management tools to
address this nPartition. This value should be consistent with the IP
address used by the nPartition when an operating system is booted.
Specifies the core cell choices. One to four core cell choices can be
specified.
Remove the specified cell from the nPartition.
parmodify 93