HP Rx2620-2 - Integrity - 0 MB RAM Manual page 66

When parcreate successfully creates a new nPartition, it reports Partition Created
and reports the nPartition number (partition number is...).
If parcreate detects any problems or issues when it creates the nPartition, it lists them in
its output. If it cannot create the nPartition, parcreate reports Command failed and
provides details.
parcreate command: cell attributes explanation
option specifies the cell numbers and attributes to be used when you create the new
nPartition. The cell local memory attribute is optional.
• -c cell:[cell_type]:[use_on_next_boot]:[failure_usage][:clm]
This option specifies the cell ID (cell) to be assigned to the nPartition.
— The only valid cell_type value is base (base cell, the default).
— The valid use_on_next_boot values for cells are:
— The only valid failure_usage value is ri (reactivate with interleave, the default).
— You can specify the clm value in either of two forms: percentage or absolute amount
3. Use the parmodify command to modify the configuration of the new nPartition
configuration and set the nPartition name (-P), boot paths (-b, -s, and -t), and any core
cell choices (-r). On HP Integrity servers, you must set nPartition boot paths from the local
nPartition.
When using the parmodify command, you must use the -p# option to specify the partition
number for the nPartition. Use the partition number that the parcreate command reported
in the previous step.
# parmodify -p1 -P "hostname05"
Command succeeded.
# parmodify -p1 -r0/4 -r0/6
Command succeeded.
# parmodify -p1 -b 4/0/1/0/0.9
Command succeeded.
#
When each modification takes place, parmodify reports Command succeeded. Otherwise,
it reports any problems.
You can specify each configuration option on a separate command line or can combine all
options into a single, longer command line.
66 Using Other Tools to Manage nPartitions
Participate in reboot (the default).
y
Do not participate in reboot.
n
of memory.
◦ Percentage cell-local memory (CLM)
The percent number can be any number in the range 0–100 with a suffix of %.
This number is rounded to 12.5%, 25%, 37.5%, 50%, 62.5%, 75%, 87.5% or 100%.
If the cell contains less than 4 GB of memory, then the percentage is rounded
to 25%, 50%, 75% or 100%. Percentages are rounded up or down to the nearest
value, but are not rounded up to 100%.
◦ Absolute CLM specification (the default)
The absolute number is interpreted as an absolute number of gigabytes of
memory and can optionally have a suffix of GB.
As needed, an absolute CLM specification is rounded up to the nearest 0.5 GB.
If the clm value is rounded, the command reports the final value used.
The parcreate command -c...