Epson Expression 800 User Manual page 59

SilverFast Lite doesn't start.
Problem
The scanner isn't ready Make sure your scanner is turned on and the cables are connected
Your system doesn't
meet the minimum
requirements
SilverFast Lite needs
more memory
SilverFast Lite is not
selected as your
TWAIN source
Your SCSI settings are
incorrect
A system error has
occurred
Troubleshooting
Solution
properly. Also make sure you turned on your scanner before starting
SilverFast Lite. If you started SilverFast Lite first, exit the program, turn
off your scanner, turn it on again, and reboot your system.
Make sure your computer, scanner, and software are compatible and
meet the specifications listed in Setting Up and Using Your Scanner .
Make sure SilverFast Lite can access enough system memory. See the
section on memory allocation in your computer manual.
SilverFast Lite may not be selected as the TWAIN source in your
application. See Accessing SilverFast Lite
You may have selected the wrong port number or SCSI ID during setup.
Check the settings for your scanner and any other SCSI devices you
may have. Then reinstall SilverFast Lite following the instructions in
Setting Up and Using Your Scanner . Make sure you are using a unique
ID address for the scanner.
An error condition may have caused your application or SilverFast Lite
to stop working correctly. Save any documents in process, close any
open applications, and exit your operating system. Restart Windows or
your Macintosh, then start your application and try again.
Sometimes an error condition causes the computer to display a
message that your scanner is not recognized. If this happens, turn the
scanner off and then on again; then restart your computer and try again.
for instructions on selecting it.
Page 59