Gigabyte GA-970A-DS3 User Manual page 24

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
ProcOdt(ohms)
DQS Drive Strength
Data Drive Strength
MEMCLK Drive Strength
Addr/Cmd Drive Strength
CS/ODT Drive Strength
CKE Drive Strength
** DCTs Addr/Cmd Timing **
Addr/Cmd Setup Time
Addr/Cmd Fine Delay
CS/ODT Setup Time
CS/ODT Fine Delay
CKE Setup Time
CKE Fine Delay
Channel Interleaving
Bank Interleaving
DQS Training Control
CKE Power Down Mode
Memclock tri-stating
: Move Enter: Select
F5: Previous Values
CPU Host Clock Control, CPU Frequency (MHz), Set Memory Clock, Memory Clock
&
The settings under the four items above are synchronous to those under the same items on the MB Intelligent
Tweaker(M.I.T.) main menu.
DCTs Mode
&
Allows you to set memory control mode.
Ganged Sets memory control mode to single dual-channel.

Unganged Sets memory control mode to two single-channel. (Default)

DDR3 Timing Items
&
Manual allows all DDR3 Timing items below to be configurable.
Options are: Auto (default), Manual.
1T/2T Command Timing
&
Options are: Auto (default), 1T, 2T.
CAS# latency
&
Options are: Auto (default), 5T~14T.
RAS to CAS R/W Delay
&
Options are: Auto (default), 2T~19T.
Row Precharge Time
&
Options are: Auto (default), 2T~19T.
Minimum RAS Active Time
&
Options are: Auto (default), 8T~40T.
TwTr Command Delay
&
Options are: Auto (default), 4T~9T.
Trfc0 for DIMM1, DIMM3
&
Options are: Auto (default), 90ns, 110ns, 160ns, 300ns, 350ns.
Trfc1 for DIMM2, DIMM4
&
Options are: Auto (default), 90ns, 110ns, 160ns, 300ns, 350ns.
DRAM Configuration
[Auto] 60 [Auto] 240
[Auto] 1.0x [Auto] 1.0x
[Auto] 1.0x [Auto] 1.0x
[Auto] 1.25x [Auto] 1.25x
[Auto] 1.5x [Auto] 1.5x
[Auto] 1.5x [Auto] 1.5x
[Auto] 1.5x [Auto] 1.5x
DCT0 DCT1
[Auto] 1/2T [Auto] 1/2T
[Auto] 0/64 [Auto] 0/64
[Auto] 1/2T [Auto] 1/2T
[Auto] 0/64 [Auto] 0/64
[Auto] 1/2T [Auto] 1/2T
[Auto] 0/64 [Auto] 0/64
[Enabled]
[Enabled]
[Skip DQS]
[Disabled]
[Disabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 24 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults