Table of Contents
Advertisement
M
aintenance and care
to maximize performance and extend
life of your vacuum it is very important to
perform the following maintenance steps.
empty dirty container
empty when dirt reaches the "full" line
on the container
1. Turn power OFF. Unplug power cord from
electrical outlet.
2. Slide Lock 'n Seal lever left to "Unlock"
position.
3. Grasp dirt cup portion handle and pull straight
out to remove from vacuum and empty.
4. Place dirt container back in the vacuum
and slide lever right to lock position.
note: the dirt container may be
washed in warm water with mild
detergent. Make sure it is complete-
ly dry before replacing.
cleaning upper tank of dirt container
1. Turn Power OFF. Unplug power cord from
electrical outlet.
2. Remove and Empty Dirt Container as
instructed in previous section.
3. With dirt container removed, grasp inner
cyclone screen and twist to the right until the
locking tabs stop the rotation. Gently pull
the inner cyclone screen down and out to
remove it.
4. Clean inner cyclone screen with a damp
cloth or mild cleaning solution. Let screen
completely dry before replacing.
5. Wipe out the inside of the upper tank and
inner cyclone with a damp cloth.
note: let completely dry before
reassembling inner cyclone screen.
6. To reassemble, line up the inner cyclone
screen inside the upper tank with "FRONT"
graphic facing you, slide into upper cyclone
and rotate to the left until the locking tabs
stop the rotation. When properly assembled
the "FRONT" graphic should face out.
10
w w w . b i s s e l l . c o m
2
3
3
6
8 0 0 . 2 3 7 . 7 6 9 1
Advertisement
Table of Contents
