Changing The Light Bulb - Bissell Trilogy Vacuum User Manual

M
aintenance and care
turbobrush
note: Model 81M9-1 comes with
the pet turbobrush
follows same maintenance
instructions.
Turn power OFF. Unplug vacuum cord
1.
from electrical outlet
Twist collar so opening is at the top
2.
and lift top cover to remove
Remove the brush from the drive belt to
3.
clean debris.
Reposition the drive belt on the brush,
4.
and place ends of brush in slots on the
side.
Reposition top cover making sure to
5.
line up inside tab at the front with the
opening of the cover. Twist collar until
opening is at the bottom to lock into
place.

changing the light bulb

1. Turn power switch off.
2. Unplug cleaner from electrical outlet.
3. Recline handle for easier access to light
bulb. Using a screwdriver or coin, gently
pry lens cover from foot.
4. Remove the bulb from the socket by
grasping the bulb and pulling gently.
Install the new bulb by pushing it gently
into the socket until the bulb snaps into
place.
5. Reposition the lens over headlight by first
inserting tab on lower portion of the cover
into the vacuum foot. Push gently on cover
to lock tabs into place.
w w w . b i s s e l l . c o m
tool maintenance
®
tool and
®
2.
4.
5.
Tip:
TurboBrush may not be turning
due to loss of suction. Refer to
pg. 11 for checking and
cleaning clogs.
3
4
8 0 0 . 2 3 7 . 7 6 9 1
15