Canon 4205B002 User Manual page 910

The ink absorber is almost full.
Press OK to continue printing.
Contact the service center.
Printer error has occurred.
Contact the service center.
Timeout error has occurred.
Press OK.
Incompatible device detected.
Remove the device.
Failed to scan head alignment sheet.
Check orientation/position and check
that platen/sheet is clean.
<See manual>
An unsupported USB hub is connected.
Remove the hub.
B200
Printer error has occurred.
Unplug the power cord and contact the
service center.
****
Printer error has occurred.
Turn off power then back on again. If
problem persists, see the manual.
The ink absorber is almost full.
button to continue printing. Contact
Press the machine's
OK
the service center.
The machine error has occurred.
Contact the service center.
Some errors occurred while copying and a certain time
passed.
Press the button to dismiss the error, and try to copy
OK
again.
Check the device connected to the Direct Print Port.
Printing photos directly is possible with a PictBridge
compliant device or the optional Bluetooth Unit BU-30, or
a USB flash drive.
A communication time out occurs if an operation takes
too long or if it takes too much time to send data. This
may cancel printing. In such cases, disconnect and
reconnect the USB cable.
When printing from a PictBridge compliant device,
depending on the model or brand of your device, you may
have to select a PictBridge compliant print mode on the
device before connecting it to the machine. You may also
have to turn on your device or select Play mode manually
after connecting the device to the machine. Perform
necessary operations before connecting your device
referring to its instruction manual.
If the error is still not resolved, check if you can print
another photograph.
Scanning the print head alignment sheet has failed.
Press the button to dismiss the error, then take the
OK
actions described below.
Make sure that the print head alignment sheet is set in
the correct position and orientation on the Platen Glass.
Make sure the Platen Glass and the print head alignment
sheet are not dirty.
Make sure the type and size of loaded paper is suitable
for Automatic Print Head Alignment.
For Automatic Print Head Alignment, always load one
sheet of A4 or letter-sized plain paper.
Make sure if Print Head nozzles are clogged.
Print the nozzle check pattern to check the status of the
Print Head.
Routine Maintenance
If the error is not resolved, connect the machine to the
computer and align the Print Head on the printer driver.
Aligning the Print Head Position
If a PictBridge compliant device is connected via a USB hub,
remove the hub and connect it directly to the machine.
Turn off the machine, and unplug the power cord of the
machine from the power supply.
Contact the service center.
Important
If you disconnect the power plug, all the documents
stored in memory are deleted.
"****" is displayed in the alphanumeric character and
depends on the error occurred.
5100 is displayed:
Cancel printing, turn off the machine. Then clear the