Table of Contents
Advertisement
Checking total memory
When you add or remove a memory module, you can check
that the computer has recognized the change. To do this:
1
Click Start, then click Control Panel.
2
Click Performance and Maintenance.
3
Click System.
4
The General tab view automatically appears and shows
total memory.
If the computer does not recognize the memory
configuration, turn off the computer, remove the memory slot
cover, and make sure the memory module is seated properly,
as described in step
page 53.
Using the TouchPad
The TouchPad, the small, smooth square cutout located in
front of the keyboard, is sensitive to touch and enables you to
move the cursor with the stroke of a finger. Simply move
your finger on the TouchPad in the direction you would like
to move the cursor:
To move the cursor to the top of the page, push your
finger forward on the TouchPad.
To move the cursor to the bottom of the page, drag your
finger toward yourself.
To move the cursor to the right side of the page, slide
your finger across the TouchPad from left to right.
To move it to the left side, slide your finger from right to
left.
Using the TouchPad™
11
of
"Adding memory"
™
Getting Started
starting on
59
Advertisement
Table of Contents
