Snare Pad Type; Pedal Types - Yamaha DTX400K Owner's Manual

Setting Parameters using Menu Mode

5-3. Snare Pad Type

Steps:
MENU ([KIT] + [SONG])  [5]  [3]  Setting
Using the following procedure, you can specify the type of
snare pad connected to your drum module.
1.
While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2.
Press number button [5] to select the Trigger Settings
parameter group.
3.
Press number button [3] to select the Snare Pad Type
parameter.
4.
Select a new snare pad type using the corresponding
number button ([1] to [6]). The available settings are as
follows.
Number button
[1]
[2]
[3]
[4]
[5]
[6]
NOTE
• This parameter can normally be set to [1] (automatic identifica-
tion).
• When set to [1], the drum module will automatically identify the
type of snare pad that came with your electronic drum kit when it
is turned on. If you then press and hold number button [1], the
drum module will flash number button [2] or [3] to indicate the
result of automatic identification.
• Whenever you change the type of snare connected to the drum
module, please update this setting using the corresponding
number button ([2] to [6]).
• You can use setting [5] or [6] to switch (or reverse) the drum
sounds assigned to Rim 1 and Rim 2. This makes it easier for
left-handed drummers to configure their electronic drum kit.
48
DTX400K/DTX430K/DTX450K
Setting
Setting
Automatic identification
TP70S
Snare pad that comes with DTX400K
XP-series pad
TP70S reversed
XP-series pad reversed
Owner's Manual

5-4. Pedal Types

Steps:
MENU ([KIT] + [SONG])  [5]  [4]  Setting
Use the following parameter to specify the types of pedals
(i.e., hi-hat controller and kick) connected to your drum
module.
1.
While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2.
Press number button [5] to select the Trigger Settings
parameter group.
3.
Press number button [4] to select the Pedal Types
parameter.
4.
Select a new pedal type combination using the corre-
sponding number button ([1] to [5]). The available set-
tings are as follows.
Number
button
Hi-hat controller
[1] Automatic identification
[2] HH65
Hi-hat controller pedal
[3] that comes with
DTX400K
Hi-hat controller pedal
[4] that comes with
DTX400K
[5] HH65
NOTE
• This parameter can normally be set to [1] (automatic identifica-
tion).
• When set to [1], the drum module will automatically identify the
type of pedal that came with your electronic drum kit when it is
turned on.
If you then press and hold number button [1], the drum module
will flash number button [2] or [3] to indicate the result of auto-
matic identification.
• Whenever you change the type of hi-hat controller or kick pedal
connected to the drum module, please update this setting using
the corresponding number button ([2] to [5]).
Setting
Setting
Kick pedal
KP65
KU100
KP65
KU100