Pad Panning; Double Bass Drum; Reverb - Yamaha DTX400K Owner's Manual

2-3. Pad Panning

Steps:
MENU ([KIT] + [SONG])  [2]  [3]  Setting
Using the following procedure, you can adjust the panning
of the current kit's pads.
1.
While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2.
Press number button [2] to select the Kit Settings
parameter group.
3.
Press number button [3] to select the Pad Panning
parameter.
4.
Strike a pad to select it.
5.
Enter a new panning position using number buttons [1]
to [10/0]. A value of 64 corresponds to the center posi-
tion. Smaller values than this move the pad increasingly
towards the left; larger values move it towards the right.
Setting
0 to 127

2-4. Double Bass Drum

Steps:
MENU ([KIT] + [SONG])  [2]  [4]  Setting
Using the following procedure, you can easily configure the
drum module to produce a kick drum sound when you oper-
ate the pedal connected to the [HI-HAT CONTROL] trig-
ger input jack. This convenient function provides support
for double bass drumming techniques.
1.
While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2.
Press number button [2] to select the Kit Settings
parameter group.
3.
Press number button [4] to select the Double Bass Drum
parameter.
4.
Set the parameter using number button [1] or [2]. The
available settings are as follows.
Number button
[1] Off
[2] On
NOTE
While the Double Bass Drum function is enabled, you will be
unable to use the hi-hat controller plugged into the [HI-HAT CON-
TROL] trigger input jack to simulate opening and closing of the hi-
hat.
Setting
Setting
Setting
Setting Parameters using Menu Mode

2-5. Reverb

Steps:
MENU ([KIT] + [SONG])  [2]  [5]  Setting
Reverb effects add a warm ambience to sounds, simulating
the complex reflections of actual performance spaces, such
as a concert hall or a small club. Use the following proce-
dure to select a reverb effect for the current kit.
1.
While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2.
Press number button [2] to select the Kit Settings
parameter group.
3.
Press number button [5] to select the Reverb parameter.
4.
Select a reverb effect using the corresponding number
button ([1] to [10/0]). The available settings are as fol-
lows.
Number button
[1] Off
[2] Hall 1
[3] Hall 2
[4] Hall 3
[5] Room 1
[6] Room 2
[7] Room 3
[8] Stage 1
[9] Stage 2
[10/0] Plate
DTX400K/DTX430K/DTX450K
Setting
Setting
43
Owner's Manual