Creating An Original Effect - Yamaha Clavinova CVP-601 Reference Manual

3
Use the [3]/[4] buttons to select the part to which you want to apply the effect.
Note that a part cannot be selected if "REVERB" or "CHORUS" is selected, or if the CONNECTION
parameter of "DSP1" is set to "System" (in step 3 of "Creating an Original Effect" below). This is because
only one of the Effect Types can be selected to be commonly applied to all available Parts.
4
Use the [5]/[6] buttons to select the effect CATEGORY.
5
Use the [7]/[8] buttons to select the effect TYPE.
If you want to edit the effect parameters, go on to the next operation.

Creating an Original Effect

1
Once you've selected an Effect Block and Effect Type above, press the [F] button to
call up the display for editing the effect parameters.
2
If you have selected one of the DSP2-4 effect blocks:
You can edit both the conventional parameters and the convenient Variation parameter. Press the [E] button
to move the cursor to the Variation parameter, then edit the value via the [6/[7] buttons. This
parameter is effective only when the DSP VARIATION is on. To move the cursor to the normal
parameters, press the [B] button.
The Variation parameter can be turned on or off by pressing the [VOICE EFFECT]  [5
NOTE
change the sound of the effect.
2
3
Select the desired parameter for editing by using the [4]/[5] buttons, then
adjust the value by using the [6]/[7] buttons.
If you have selected the REVERB, CHORUS or DSP1 effect block, you can adjust the Effect Return Level
by pressing [8] button.
To re-select the Effect block, category and type, use the [1] – [3] buttons. The re-selected effect
configuration is displayed at the upper left side box in the display.
Keep in mind that in some cases noise may result if you adjust the effect parameters while playing the instrument.
NOTE

] (DSP VARIATION). This lets you instantly and significantly
3
4
CVP-601 Reference Manual
9
75