Yamaha Clavinova CVP-601 Owner's Manual page 99

2
Attach B.
Align the screw holes on the upper side of B with
the bracket holes on D and E, then attach the
upper corners of B to D and E by finger-
tightening two thin screws (4 x 12 mm).
Secure the bottom end of B using four tapping
screws (4 x 20 mm).
Securely tighten the screws on the top of B that
were attached in step 2-
E E
B
3
Mount A.
CAUTION
• Be extra careful not to drop or let your fingers be
pinched by the main unit.
• Do not hold the main unit in any position other than the
position specified.
Be sure to place your hands at least 15cm from
either end of the main unit when positioning it.
Align the screw holes
15cm or further in
4
Secure A.
Adjust the position of A so that the left and right
ends of A will project beyond D and E equally (as
seen from the front).
Secure A by tightening six short screws (6 x 16
mm) from the front.
.
D D
A A
A A
5
Connect the pedal cord and power cord.
Insert the plug of the pedal cord into the pedal
connector.
Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
Use a vinyl tie to take up any slack in the pedal
cord.
Insert the plug of the power cord into the power
connector.
Insert the pedal cord securely
until the metal part of the cord
plug disappears from view.
Otherwise, the pedal may not
function properly.
A A
CVP-601 Owner's Manual 99