Dell Precision 410 User Manual page 69

NOTE: Before you assign a new system and/or setup password, you must
replace the PSWD jumper plug.
Booting with the PSWD jumper installed reenables the password features. When
you enter the System Setup program, both password fields appear as Not
Enabled, meaning that password protection is no longer available because no
passwords have been assigned.
To assign a new system password, see "Assigning a System Password" found
earlier in this chapter. To assign a new setup password, see "Assigning a Setup
Password" found earlier in this chapter.
See "Chassis Intrusion" found earlier in this chapter.
If an error message appears on your monitor screen while the system is booting,
make a note of the message. Then, before entering the System Setup program, refer
to your Diagnostics and Troubleshooting Guide for an explanation of the message and
suggestions for correcting any errors. (However, it is normal to receive an error mes-
sage the first time you boot the system after a memory upgrade. In that case, you do
not need to refer to the Diagnostics and Troubleshooting Guide —follow the instruc-
tions in "Performing a Memory Upgrade" in Chapter 8 of this guide.)
If you are given an option of pressing either <F1> to continue or <F2> to run the Sys-
tem Setup program, press the <F2> key.
HQDEOH
Using the System Setup Program 3-25