Partitioning And Formatting Scsi Hard-Disk Drives - Dell Precision 410 User Manual

Dell Precision 410 Mini Tower Systems User's Guide
10-20
If you are installing an external SCSI device , connect one end of the external SCSI
cable to the SCSI bus connector on the back of the device. Attach the other end
of the external SCSI cable to the SCSI connector on the system back panel.
NOTE: Dell offers an external SCSI 68-pin-to-50-pin adapter kit for connecting
SCSI-3 devices to the SCSI-2 connector on the Precision 410 system back panel.
Contact your Dell sales representative for more information.
If you are installing an internal SCSI device , connect a DC power cable to the
power input connector on the SCSI device.
If you are installing an external SCSI device , connect the socket end of the
power cable into the AC power receptacle on the back of the SCSI device.
Connect the other end of the power cable into a standard electrical wall
outlet.
Check all other cable connections. Fold all internal cables out of the way to pro-
vide airflow for the fan or cooling vents.
For instructions, see "Removing and Replacing the Front Bezel" and "Removing
and Replacing Front-Panel Inserts" found earlier in this chapter.
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
See Chapter 3, "Using the System Setup Program," for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
For any SCSI devices, the respective category under Drives: Primary or Drives:
Secondary should be set to None. For instructions, see Chapter 3, "Using the
System Setup Program."
For instructions, see the next subsection, "Partitioning and Formatting SCSI
Hard-Disk Drives," and your operating system documentation.