NEC NP-PX700W User Manual page 189

Attaching Stacking Holders
Attach three stacking holders to three locations on the top of the lower projector.
Preparation:
Tools required are Phillips screwdriver (plus-head) and three stacking holders packaged with the projector.
Loosen the tilt feet (three locations) of the projector.
1. Remove rubber caps and screws at three locations.
(1) Use your tweezers or nail to pinch and pull up the rubber cap.
(2) Remove the screw from a square hole.
(1)
2. Attach the three stacking holders at three locations.
(1) Place a stacking holder in a square hole.
(2) Use the screw removed at Step 1 to fix the stacking holder in the square hole.
(3) Put the rubber cap removed at Step 1 back into the square hole.
• Snap the tabs on both of the rubber cap into the slits on both sides in the square hole.
(1)
(2)
(2) (3)
6. Installation and Connections
175