Lubrication; Agitator Brushroll - Hoover UH20060 Owner's Manual

3-20
Slide belt over motor shaft (H).
3-23
the agitator brushroll
When to replace
When agitator brushroll brushes are
worn, the agitator brushroll should be
replaced.
Disconnect cleaner from electrical
outlet .
WARNING: Agitator brushroll can
start suddenly . Unplug cleaner
before turning it over .
What to buy
When purchasing a new agitator, ask
for HOOVER part No .
2BEA131001900 .
To check condition of brushes, move
edge of a card across bottom plate
while turning agitator brushroll. To
maintain cleaning effectiveness,
replace agitator brushroll if brushes
do not touch card.
To remove agitator, follow Items 3-10
through 3-15.
Install new agitator brushroll following
Items 3-18 through 3-22.
3-21
H
Align belt between "U" shaped posts.
Reposition hood and replace 2 hood
screws.

Lubrication

The motor is equipped with bearings
that contain sufficient lubrication for
the life of the motor. The addition of
lubricant could cause damage.
Therefore, do not add lubricant to
motor bearings .
The agitator brushroll is equipped
with two ball bearings that should be
lubricated periodically by a Hoover
Sales and Service Center or an
Authorized Hoover Warranty Service
Dealer.
3-22
With bottom of cleaner facing up,
replace 2 bottom screws.
Continued ➜
11