If You Have A Problem; Lubrication; Secondary Filter; Service - Hoover S1420050 Owner's Manual

3-9
Place tab on bag door into slot in lower
front of cleaner. Close door.
NOTE: Cloth bag may be washed in
warm water. It must be thoroughly dry
before replacing it in the cleaner.

Service

To obtain approved HOOVER service
and genuine HOOVER parts, locate the
nearest Hoover Factory Service Center
or Authorized Hoover Warranty Service
Dealer (Depot) by:
• checking the Yellow Pages
under "Vacuum Cleaners -
Household" OR -
• checking the list of Factory
Service Centers provided with
this cleaner OR -
• calling 1-800-944-9200 for an
automated referral of
authorized service outlet
locations (U.S. only) OR -
• checking the Service section
of The Hoover Company online
at www.hoovercompany.com
Please do not send your cleaner to The
Hoover Company in North Canton for
service, this will only result in delay.
If further assistance is needed,
contact The Hoover Company
Consumer Response Center, North
Canton, Ohio 44720
Phone: 1-330-499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8,
Phone: 1-800-263-6376.
3-10

Secondary filter

Disconnect cleaner from electrical outlet.
The secondary filter protects the motor
from dirt particles. It is
located on the back wall behind the bag.
When bag is removed, check the filter (it
is not removable).
Loosen dirt with a small brush and wipe
off dirt particles with a slightly damp
cloth. Dry thoroughly.
Always identify your cleaner by the
complete model number when request-
ing information or ordering parts. (The
model number appears on the bottom
of the cleaner.)
4. If you have
a problem
If a minor problem occurs, it usually
can be solved quite easily when the
cause is found by using the check list
below.
Rug and floor nozzle
To maintain the cleaning effectiveness of
your rug and floor nozzle, the brushes
may need to be replaced occasionally.
See your nearest Hoover Factory Service
Center or Authorized Warranty Dealer
(Depot) for
new brushes.

Lubrication

The motor is equipped with two
bearings that contain sufficient
lubrication for the life of the motor. The
addition of lubricant could cause damage.
Therefore, do not add
lubricant to either motor bearing.
7