Hoover UH20060 Owner's Manual page 10

3-11
Remove 2 screws from bottom plate.
3-14
Lift agitator cover off.
3-17
position new belt on agitator
brushroll
With lettering on outside of belt, insert
agitator brushroll through belt and
position belt in groove (F) on agitator
brushroll.
10
3-12
Removing hood
Lower cleaner base so it is flat on the
floor.
Remove 2 screws located at back of
hood (A). Lift hood off.
3-15
C
Grasp agitator (C) and pull up to
remove from agitator cavity.
3-18
G
F
Installing agitator brushroll
Grasp agitator brushroll firmly and fit it
into position by first sliding end oppo-
site the belt into the rectangular slot
(G) on side of cleaner.
Pull other side of agitator brushroll
into place.
3-13
Remove 2 screws on agitator cover
(B).
3-16
Slide belt (D) off agitator.
Remove belt from motor shaft (E).
Discard used belt.
3-19
Reposition agitator cover over
agitator. Replace 2 screws.
B
D
E