Lenovo ThinkServer RD240 Hardware Maintenance Manual page 62

Figure 23. Installing the optical drive cage retaining screw
14. Connect the power cable (P8) and the signal cable (SATA cable) to the rear of the optical drive.
15. Reinstall the drive access panel and secure it in place by the four screws (one on each side and two
on the top of the optical drive) that you have removed in step 4.
16. To complete the installation, go to Completing the parts replacement.
Removing a hot-swap hard disk drive
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 35.
This section provides instructions on how to remove a hot-swap hard disk drive. This section applies only to
server models that have hot-swap hard disk drives installed.
Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without
either a drive or a filler panel installed in each drive bay.
To remove a hot-swap hard disk drive, do the following:
Note: You do not have to turn off the server when removing a hot-swap hard disk drive.
1. Press the blue latch to open the hard disk drive tray (
tray assembly to the open position (
assembly out of the bay (
50
ThinkServer RD240 Hardware Maintenance Manual
2 ). Then, grasp the handle and pull the hard disk drive tray
3 ).
1
) and rotate the handle of the hard disk drive