Removing Or Installing Internal Drives - Lenovo ThinkServer RD240 Hardware Maintenance Manual

3. Locate the memory slot with the memory module that you want to remove. See Locating parts on the
system board for the locations of the memory slots.
4. Carefully open the retaining clips on each end of the memory slot and then grasp the memory module
straight up by its edges.
Figure 11. Removing the memory module
5. If you are instructed to return the failing memory module, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
6. To complete the removal procedure, go to Completing the parts replacement.

Removing or installing internal drives

This section provides instructions on how to remove or install internal drives for the server.
See Specifications for information about the types of internal drives that the server supports and other
important information, and see Front view for the locations of the drive bays in the server.
When installing an internal drive, be sure to consider the following information:
• Make sure that you have all the cables and other equipment that is specified in the documentation that
comes with the drive.
• Select the drive bay in which you want to install the drive.
• Check the instructions that come with the drive to see whether you have to set any switches or jumpers
on the drive. If you are installing a SAS device, be sure to set the SAS ID for that device.
• The EMI integrity and cooling of the server are protected by having all bays, PCI slots, and PCI Express
slots covered or occupied. When you install a drive, PCI card, or PCI Express card, save the EMC
shield and filler panel from the bay, PCI card slot, or PCI Express card slot in the event that you later
remove the device.
• For a list of the supported hard disk drives for your server, go to http://www.lenovo.com/thinkserver. On
the ThinkServer systems page, click Products ➙ Options ➙ ThinkServer Hard Drives.
Removing the optical drive
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 35.
This section provides instructions on how to remove the optical drive.
To remove the optical drive, do the following:
.
Chapter 7 Installing, removing, or replacing hardware
41