Lenovo ThinkServer RD240 Hardware Maintenance Manual page 127

Table 26. Submenus under the CPU Configuration (continued)
Item
ACPI T State
Notes:
1. The settings in [ ] are the default settings in the Setup Utility program.
2. The above options might vary depending on the type of the installed microprocessor.
Table 27. Submenus under the Mass Storage Controller Configuration
Item
SATA Configuration
Configure SATA as
Notes:
1. The settings in [ ] are the default settings in the Setup Utility program.
2. The SATA Configuration item might not apply because your server came with an integrated SAS controller.
Table 28. Submenus under the SuperIO Configuration
Item
Serial Port1 Address
Serial Port2 Address
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 29. Submenus under the USB Configuration
Item
Legacy USB Support
USB 2.0 Controller Mode
Hotplug USB FDD Support
Note: The settings in [ ] are the default settings in the Setup Utility program.
For external USB devices, the USB Mass Storage Device Configuration submenu is as below:
Emulation Type
Option
Disabled[Enabled]
Option
Disabled[Enabled]
[IDE]RAID
Option
Disabled[3F8/IRQ4]3E8/IRQ42E8/IRQ3 Select the I/O base address and
Disabled[2F8/IRQ3]3E8/IRQ42E8/IRQ3 Select the I/O base address and
Option
Disabled[Enabled]Auto
FullSpeed[HiSpeed]
DisabledEnabled[Auto]
[Auto]FloppyForced FDDHard
DiskCDROM
Description
Enable or disable the microprocessor
throttling in ACPI.
Description
Enable or disable the integrated SATA
controller.
To select the hard disk drive mode.
If this option is set to IDE, all the
SATA connectors will be configured
as stand-alone SATA connectors.
Description
interrupt for serial port 1.
interrupt for serial port 2.
Description
Enable or disable the support on
legacy USB devices.
Select the USB speed.
Enable or disable the support on the
hot-swap USB diskette drive.
Select the type of the USB device.
.
Chapter 9 Configuring the server
115