Problems When Projection Starts; Other Problems - Epson Dreamino EMP-TW20 User Manual

Problem Solving
Have the colour intensity and
tint been adjusted correctly?
Only when projecting
images from a video
source
Images appear dark
Has the image brightness been
adjusted correctly?
Has the image contrast
been adjusted correctly?
Is the lamp due for
replacement?
Projection stops automatically
Is sleep mode active?

Problems when projection starts

Power does not turn on
Have you pressed the [Power]
button?
Is "Child Lock" set to "ON"?
Are all of the indicators
switched off?
Do the indicators turn off and
on when the power cable is
touched?

Other problems

No sound can be heard or the sound is faint
Is the audio source connected
correctly?
Has the volume been adjusted
to the minimum setting?
Is A/ V Mute mode active?
38
Use the "Color Saturation" and "Tint" menu commands to adjust the
colour and tint.
"Image"- "Picture Quality" - "Color Saturation", "Tint" p.26
Use the "Brightness" menu commands to make the adjustments.
"Image" - "Picture Quality" - "Brightness" p.26
Use the "Contrast" menu command to adjust the contrast.
"Image" - "Picture Quality" - "Contrast" p.26
When the lamp is nearly due for replacement, the images will
become darker and the colour quality will become poorer. When this
happens, the lamp should be replaced with a new one.
When "Sleep Mode" has been set to ON, the lamp turns off
automatically if no signal is input for about 30 minutes, and the
projector switches to standby mode. Press the
remote control or the button on the projector's control panel to
turn the projector's power back on. To cancel the sleep mode setting,
change "Sleep Mode" menu command to "OFF".
"Setting" - "Operation" - "Sleep Mode" p.29
Press on the remote control or
panel.
If the "Child Lock" menu command is set to "ON", press
projector's control panel for about 3 seconds or press
remoto control to turn the power on.
"Setting" - "Operation" - "Child Lock" p.29
Disconnect the power cable and then reconnect it.
Check the circuit breaker to see if power is being supplied.
Turn the power off, disconnect the power cable and then reconnect it. If this
does not solve the problem, there may be a problem with the power cable.
Then contact your dealer or the nearest address provided at "International
Warranty Conditions" in Safety Instructions/World-Wide Warranty Terms
booklet.
Check that the cable is connected to the [Audio] input port.
Adjust the volume so that sound can be heard.
Press on the remote control to cancel the A/V mute.
p.42
button on the
on the projector's control
on the
on the
p.14
p. 17