Selecting The Image Source; Turning The Power Off - Epson Dreamino EMP-TW20 User Manual

Selecting the image source

Selecting the image source
If more than one signal source has been connected, or if no images are projected, use the remote
control or the projector's control panel buttons to select the signal source.
Using the remote control
Press the button that has the name of the port on it
that the desired signal source is connected to.
When [Input A] port is connected
When connecting equipment to the [InputA] port, you may need to switch the image signal to match the
equipment.
< Remote control >
While projecting an image from equipment
connected to the [InputA] port(s), press
to display the selection menu.
Selection
menu
If there is a problem with projection even though the projector is set up
and connected correctly, refer to
TIP

Turning the power off

Turning the power off
Turn the power off for the signal
sources that are connected to the
projector.
Remote Control
Press .
Control Panel
Pressing will display the following
message, so press
Using the control panel
When you press
Use
Press
Use
equipment.
Press or to accept.
p.34.
once more.
Turning the Power on and Projecting Images
, the selection menu is displayed.
or to select the signal source.
to accept.
< Control panel >
If "InputA" is selected, the selection menu will
be displayed.
or to select the correct signal to match the
When the projector has cooled down
(takes about 20 seconds) and the
"beep beep" tone sounds, disconnect
the power cable.
Simply turning off the power does not stop
electricity consumption.
Attach the lens cover.
Disconnect the cables that are connecting
other equipment to the projector.
Selection menu
15