HP Kayak XM600 User Manual page 41

9 Slide the hard disk drive bay and speaker assembly towards the system
board until it is well clear of the chassis edge (located between the hard
disk drive bay and speaker assembly and front access cage).
10 Lift the hard disk drive bay and speaker assembly upwards to remove it
from the computer.
Replacing the Assembly
1 Ensure that there are no cables underneath the hard disk drive bay and
speaker assembly.
2 Align the two plastic tabs (control panel side) of the hard disk drive bay
and speaker assembly with their associated notches.
3 Ensure that the plastic clips on the front of the hard disk drive bay and
speaker assembly are lined-up with their associated locations.
4 From the front of the PC, gently push towards you the right-hand side of
the hard disk drive bay and speaker assembly until it clicks in place.
Repeat this procedure on the left-hand side of the hard disk drive bay
and speaker assembly.
5 Reconnect the speaker and control panel cables to their connectors on
the system board.
6 Reconnect the data and power cables. Replace the hard disk drive and
hard disk drive tray.
7 Replace the PC Workstation's cover and front bezel (refer to page 23).
Reconnect all the power and telecommunications cables.
2 Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the Hard Drive Bay and Speaker Assembly
Retention clip
41