HP Kayak XM600 User Manual page 37

NOTE
3 Slide the new drive into the shelf. Ensure that the front of the new device
is aligned with the other drive or filler plate. Secure the device in
position using the screws supplied with it.
Replacing the Front Access Drive Cage
1 Place the front access cage back into the PC. The front access cage
retainers should be correctly aligned with the bottom of the chassis.
2 Connect the power and data cables to the installed devices. For
convenience, it is recommended to start from the bottom and work
upwards. The connectors are shaped to go in one way only. If you are
not sure which connector to use, refer to "Installing Mass Storage
Devices", on page 30.
3 Ensure that the metal guides on the front access cage are aligned with
those on the chassis. (There are two on either side.) Slide the front
access cage into the chassis until it snaps into place.
To verify that the front access cage is correctly in position, check that the
"ALIGN" mark on top of the front access cage is parallel with the one on
chassis.
2 Installing and Replacing Hardware Parts in Your PC Workstation
Installing a Device in a Front Access Bay
37