HP Kayak XM600 User Manual page 23

Removing the Front Bezel
If required, remove the front bezel. To remove the bezel:
1 Push down on the two grey retaining clips.
2 Then push the blue clip inwards.
3 Tilt the bezel forwards and lift it off.

Replacing the Cover and Front Bezel
1 Ensure that all internal cables are properly connected and safely routed.
2 If necessary, replace the front bezel. To do this, align the three guide
pins located at the bottom of the bezel with their associated slots on the
front of the chassis and gently push forward until the bezel snaps into
place.
3 Lower the cover onto the PC chassis (aligning the rails on the inside
edges of the cover with the sides of the PC chassis), and firmly slide the
cover forwards until it clicks into position.
4 Tighten the thumb screw at the rear of the PC.
5 If required, lock the cover using the key provided. Reconnect all the
power and telecommunications cables.
2 Installing and Replacing Hardware Parts in Your PC Workstation
Removing and Replacing the Cover and Front Bezel





23