Intel Desktop Board D2700DC Technical Product Specification
1.11.2
Hardware Support
The board provides several power management hardware features, including:
•
Power connector
•
Fan header
•
LAN wake capabilities
•
Instantly Available PC technology
•
Wake from USB
•
Power Management Event signal (PME#) wake-up support
•
WAKE# signal wake-up support
•
+5V Standby Power Indicator LED
LAN wake capabilities and Instantly Available PC technology require power from the
+5 V standby line.
NOTE
The use of Wake from USB technologies from an ACPI state requires an operating
system that provides full ACPI support.
1.11.2.1
Fan Header
The function/operation of the fan header is as follows:
•
The fan is on when the board is in the S0 state.
•
The fan is off when the board is off or in the S3, S4, or S5 state.
•
The system fan header supports closed-loop fan control that can adjust the
fan speed and is wired to a fan tachometer input.
•
The fan header supports +12 V, 3-wire fans at 1 A maximum.
For information about
The locations of the fan header and thermal sensors
The signal names of the system fan header
1.11.2.2
LAN Wake Capabilities
LAN wake capabilities enable remote wake-up of the computer through a network.
The LAN subsystem network adapter monitors network traffic at the Media
Independent Interface. The board supports LAN wake capabilities with ACPI in the
following ways:
•
By Ping
•
By Magic Packet
Upon detecting the configured wake packet type, the LAN subsystem asserts a wake-
up signal that powers up the computer.
32
Refer to
Figure 6, page 28
Table 11, page 43