Asus M2A VM - Motherboard - Micro ATX User Manual page 34

2. USB device wake-up (3-pin USBPW1-4, USBPW5-8, USBPW910)
Set these jumpers to +5V to wake up the computer from S1 sleep mode
(CPU stopped, DRAM refreshed, system running in low power mode) using
the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep
modes.
The USBPW1-4 jumpers are for the rear USB ports. The USBPW5-8 and
USBPW910 jumpers are for the internal USB connectors that you can
connect to additional USB ports.
M2A-VM
M2A-VM USB device wake-up
•
•
3.. Keyboard.power.(3-pin.KBPWR)
This jumper allows you to enable or disable the keyboard wake-up feature.
Set this jumper to pins 2-3 (+5VSB) to wake up the computer when you press
a key on the keyboard (the default is the Space Bar). This feature requires an
ATX power supply that can supply at least 500 mA on the +5VSB lead, and a
corresponding setting in the BIOS.
M2A-VM
M2A-VM.Keyboard.power.setting
1-22
®
The USB device wake-up feature requires a power supply that can
provide 500mA on the +5VSB lead for each USB port; otherwise,
the system will not power up.
The total current consumed must NOT exceed the power supply
capability (+5VSB) whether under normal condition or in sleep mode.
®
USBPW1-4
3
2
2
1
+5V +5VSB
(Default)
USBPW5-8
2 3
1 2
+5V +5VSB
(Default)
KBPWR
2 3
1 2
+5V +5VSB
(Default)
Chapter 1: Product introduction
USBPW910
3
2
2
1
+5V +5VSB
(Default)