Table of Contents
Advertisement
4
Select
Max
as the rate.
Enter an IP address and netmask to use for the DSL/WAN interface.
5
Select
6
Modify VC
Select the "
7
Advanced Setup
Select the "
8
Command List
9
From the command list on the left, select "ipgateway".
10
Enter the "
Enter new IP address
gateway (default route) that is on the same subnet as the router.
When the response appears at the bottom of the screen, it will have
11
link that says "REBOOT REQUIRED". Click on that link and reboot
the router. Select
configuration.
Bridge Configuration
The first thing you must do to use the 5600 series router as a bridge is
change it to bridge mode.
To change mode from the HTML interface:
1
On the first page, select
2
When the display appears, select the radio button labeled
When the response appears at the bottom of the screen, it will have
3
link that says "REBOOT REQUIRED". Click on that link and reboot
the router. Select
configuration.
The only other possible configuration parameters you may need to set
would be the VPI/VCI numbers as specified by your service provider.
When the unit comes back up in bridge mode, select the
link to configure it.
Efficient Networks, Inc.
.
" button in the top left panel.
" button in the top left panel.
" field, enter the IP address of an IP
Refresh
after a minute or two to see the new
Change to Bridge Mode"
Refresh
after a minute or two to see the new
How do you want to use the Router?
.
Bridge
.
Simple Setup
27
Advertisement
Table of Contents
