Bridge Configuration; Step 1: Changing Modes; Changing To Bridge Mode Through The Web Interface; Changing To Bridge Mode Through The Command Line - Efficient Networks SpeedStream 5600 Series Installation Manual

At the FTP command prompt, type in:
4
You can upload a new revision of firmware by changing to the
5
directory where the file is stored and entering the command
5600.img
The command prompt will return when the router has finished
6
programming the firmware into memory.

Bridge Configuration

Because the 5600 is configured by default in router mode, it must be set to
bridge mode in order to function as a bridge.

Step 1: Changing Modes

You can choose one of two methods to change the router to function in
bridge mode, the web interface or the command line interface.

Changing to Bridge Mode through the Web Interface

Start your web browser
1
Enter the router's IP address:
2
On the first page, click on the link, "
3
When the display appears, click on the radio button labeled
4
Click on the button,
5
When the response appears at the bottom of the screen, it will include
6
a link that says "
to reboot the router. Select
yes
configuration.

Changing to Bridge Mode through the Command Line

Interface

The command line interface is designed for use by advanced users. Refer
to "Command Line Interface" on page 26 for more information about the
command line. Detailed instructions for using the command line interface
18 Bridge Configuration
10.0.0.1
Change Mode
REBOOT REQUIRED
Refresh
binary
Change to Bridge Mode"
". Click on that link and choose
after a minute to see the new
put
.
.
Bridge
Efficient Networks