Table of Contents
Advertisement
Router PPP Configuration
The modem is configured by default from the factory to be in router mode
using PPP encapsulation. This greatly simplifies the configuration
procedure.
To configure the router via HTML:
On the main page, click on
1
If your service provider has specified a VPI/VCI number to use, enter
2
the numbers in the VPI and VCI fields.
Enter the PPP username and password specified by your service
3
provider.
4
Select
Set
. This will set the new VPI/VCI parameters on the router .
Select
Refresh
RFC 1483 Configuration
There are two types of RFC 1483 encapsulation that can be used: RFC
1483 bridged and RFC 1483 routed.
RFC 1483 Routed encapsulation operates at the IP layer and will route
only IP packets. RFC 1483 bridged encapsulation method handles non-IP
packets, which the unit supports only while configured for use as a bridge.
The method you will use depends on the configuration parameters
specified by your internet service provider.
The procedure that follows assumes that you have a unit that is configured
with factory defaults.
To configure the modem via HTML:
On the main page, look in the Configuration Summary table and click
1
on the title
Encapsulation Protocol
2
If your service provider has specified a different VPI/VCI number to
use, enter the numbers in the VPI and VCI fields. Otherwise, enter the
default VPI and VCI values.
Select the desired RFC 1483 encapsulation.
3
26
How do you want to use the Router?
Simple Setup
after a minute or two to see the new configuration.
.
.
Efficient Networks, Inc.
Advertisement
Table of Contents
