Wireless Interface; Table 37. Wireless Setting Commands - D-Link DWL-8500AP - AirPremier AG Wireless Switching 108 Dualband Access Point Administrator's Manual

Table 36. Ethernet Setting Commands
Action
Use DHCP as the connection type
Use a Static IP as the connection
type
Set the Static IP address
Set a Subnet Mask
Set the Default
Gateway
View the DNS Nameserver mode
Dynamic= up
Manual=down
Set DNS Nameservers to Use
Static IP Addresses (Dynamic to
Manual Mode)
Set DNS Nameservers to Use
DHCP IP Addressing (Manual to
Dynamic Mode)

Wireless Interface

To set up a wireless (radio) interface, configure the Radio Mode and Radio
interface. The commands in this table use radio 1 (
radio 2, use
wlan1

Table 37. Wireless Setting Commands

Action
Enable or Disable 802.11d regulatory
domain support
Enable or Disable Station Isolation
View the current radio mode
Set the radio mode to Dynamic Turbo 5
GHz
Set the radio mode to Dynamic Turbo 2.4
GHz
Command
set management dhcp-client status up
set management dhcp-client status down
set management static-ip <ip_address>
Example:
set management static-ip 10.10.12.221
set management static-mask <netmask>
Example:
set management static-mask 255.0.0.0
set static-ip-route gateway <ip_address>
Example:
set static-ip-route gateway 10.10.12.1
get host dns-via-dhcp
set host dns-via-dhcp down
set host static-dns-1 <ip_address>
set host static-dns-2 <ip_address>
Example:
set host static-dns-1 192.168.23.45
set host dns-via-dhcp up
.
B CLI for AP Configuration
). To change the wireless settings for
wlan0
Command
set dot11 dot11d up
set dot11 dot11d down
set radio wlan0 station-isolation on
set radio wlan0 station-isolation off
get radio wlan0 mode
set radio wlan0 mode dynamic-turbo-a
(only applicable for radio interface
wlan0)
set radio wlan0 mode dynamic-turbo-g
(only applicable for radio interface
wlan1)
Access Point CLI Commands
Channel on each
137