Additional Cli Commands; Getting Help On Commands At The Cli; Tab Completion; Table 31. Additional Cli Commands - D-Link DWL-8500AP - AirPremier AG Wireless Switching 108 Dualband Access Point Administrator's Manual

D-Link Unified Access Point Administrator's Guide

Additional CLI Commands

The CLI also includes the following commands for maintenance tasks:

Table 31. Additional CLI Commands

Command
save-running
reboot
factory-reset
firmware-upgrade
config
For information about classes, instances, and properties, see
Reference"

Getting Help on Commands at the CLI

The CLI provides keyboard shortcuts to help you navigate the command line and build valid
commands, along with "tab completion" hints on available commands that match what you
have typed so far. Using the CLI will be easier if you use the tab completion help and learn the
keyboard shortcuts.

Tab Completion

Help on commands can be requested at the CLI by using the TAB key. This is a quick way to
see all valid completions for a class. Entering TAB once will attempt to complete the current
command.
If multiple completions exist, a beep will sound and no results will be displayed. Enter TAB
again to display all available completions.
Example 1: At a blank command line, enter TAB twice to get a list of all commands.
DLINK-WLAN-AP#
add
config
factory-reset
firmware-upgrade
get
reboot
remove
save-running
set
130 © 2001-2008 D-Link Corporation. All Rights Reserved.
Description
The
save-running
startup configuration.
For more information, see
page 133.
The
reboot
The
factory-reset
reboots.
Use the
firmware-upgrade
Use the
config
configuration file.
on page 150
Add an instance to the running configuration
Upload/Download the running configuration
Reset the system to factory defaults
Upgrade the firmware
Get property values of the running configuration
Reboot the system
Remove instances in the running configuration
Save the running configuration
Set property values of the running configuration
command saves the running configuration as the
"Saving Configuration Changes"
command restarts the access point (a "soft" reboot).
command resets the AP to factory defaults and
command to upload a new AP image.
command to upload or download the AP
"CLI Classes and Properties
on