Networks Without A Dhcp Server - 3Com 3CRWE915075 - AirConnect 9150 11n 2.4 GHz PoE Access Point User Manual

14

Networks without a DHCP Server

After you determine the AP's IP address, you can enter that IP
address into a web browser on a computer on the same subnet to
view the Access Point's system status or change its configuration.
Networks without a DHCP Server
If your network does not have a DHCP server, the Access Point
uses a factory assigned IP address (169.254.2.111). You can use
that IP address to configure the Access Point, or you can assign a
new IP address to the Access Point.
To verify that the Access Point is using the default IP address
assigned at the factory:
1 Connect a computer directly to the Access Point using the
2 Enter the Access Point's default IP address (169.254.2.111)
If the Configuration Management System does not start, the
Access Point is on a different subnet than the computer. Install
and start the 3Com Wireless Infrastructure Device Manager to
discover the Access Point's IP address.
supplied standard Category 5 UTP Ethernet cable.
into the computer's web browser. If the Configuration
Management System starts, the Access Point is using the
factory assigned IP address. You can configure the Access
Point with the following login information:
Login name: admin
■
Password: password
■