Software Installation; First Time Power-Up - Edelbrock QwikData 91001 Manual

When the "Installation Type" screen is displayed, click on the QwikData package that you are using and click on the "Next" button to
proceed.
Follow the on-screen instructions to complete the software installation.
NOTE: The setup program must always be utilized if installing the software on a different machine. Simply copying the ".exe" program
over will not work.

FIRST TIME POWER-UP

Connect QwikData to one of your PC's spare serial ports using the gray serial cable with the 9 pin "D" type computer connector (Note:
This is not waterproof, so keep this stowed in a dry place during operation). If your computer only has a 25-pin connector, then you
must purchase a 9 to 25 pin adapter (available anywhere computer products are sold). If you have only a USB port, use the supplied
USB to Serial Port Adapter and install the drivers on the supplied CD. The QwikData Analysis software automatically searches all the
available COM ports on your PC to find the QwikData unit. The first time you connect the QwikData unit to your PC, this search process
may take some time. Once communications with the QwikData unit is established, the software remembers the COM port. The next
time you start the program, it will check this COM port first and unless you connect the QwikData unit to a different COM port,
communications will be established quickly.
USB Adapter Installation: The drivers for the USB-Serial Port adapter cable are located on the supplied "DRIVER" CD.
Microsoft ® Windows Installation
1. For Microsoft® Windows operating systems, insert the disc into your CD-ROM drive and click on the "Install USB-to-
DB9 Serial Adapter Driver".
a. If the CD does not Auto Run, navigate to your CD-ROM drive and double click on the file named "Install USB-to-
DB9 Serial Adapter Driver".
2. When the InstallShield Wizard opens, click "Next". The Wizard will automatically install the driver.
3 Upon completion of the installation, click "Finish" to close the InstallShield Wizard.
NOTE: You may use the same program to un-install the driver if desired. Run the "PL-2303 Driver Installer"
program again and follow the prompts to un-install the driver.
Catalog #91001, 91003, 91004, 91005, 91007, 91009
Rev. 9/06 - RS/mc Page 8 of 47
©2006 Edelbrock Corporation
Brochure #63-0282