Zero Analog Channels - Edelbrock QwikData 91001 Manual

Zero Analog Channels

The QwikData program allows you to zero selected analog channels at any time. This effectively changes the calibration values so that
the current value being read on the channel is assigned as the zero point for the sensor and all readings will then be displayed as plus
and minus values referenced to this zero point. This feature is most useful for sensors such as suspension travel sensors. In this case,
the vehicle would be setup at its normal static ride height including full tanks and driver and then the suspension travel channel would
be zeroed. After being zeroed, the suspension travels values would be displayed as plus and minus values relative to the static value.
Note: This screen should not be used to zero the accelerometers that are included in the QwikData unit. To zero the accelerometers,
use the " Zero Accelerometers " selection from the "Tools " menu (see the Zero Accelerometers section below.
To zero analog channels select "Zero Analog Channels" from the "Tools" menu.
Note: the QwikData unit must be on and connected to the PC for this function to be active.
This will display the Zero Analog Channels screen.
Select each channel to be zeroed by checking the check box next to the channel name.
NOTE: Only analog channels that are currently enabled can be zeroed. When you have selected all the channels to be zeroed, click
on the " OK " button.
Catalog #91001, 91003, 91004, 91005, 91007, 91009
Rev. 9/06 - RS/mc Page 18 of 47
©2006 Edelbrock Corporation
Brochure #63-0282