Digital Outputs; Graphing Setup - Edelbrock QwikData 91001 Manual

Digital Outputs

QwikData has two configurable outputs, which can drive a Bosch type automotive relay or a small light (0.5 amps maximum).
Configuration of the digital outputs is accessed from the "Logging Setup" screen. First select whether or not the digital output will be
utilized by checking the appropriate box.
The logic selection process is similar to the start/stop triggers.
Select a sensor for the first logic condition from the list of available channels, whether you want to trigger on a < or > condition, and
the value. E.g. Oil Pressure < 20.
If a second logic condition is desired, enter the appropriate values, then select "And" or "Or" from the middle selection list e.g. Oil
Pressure < 20 or Fuel Pressure < 3.

Graphing Setup

Graphing Setup allows you to choose what variables are displayed on the graph (up to 9 can be graphed at once), what colors they are
displayed in, and the scale at which you want to display the data.
Select if you want the channel displayed or not by clicking on the "Graph" box .
Autoscale
Select if you want the system to automatically detect the minimum and maximum scale data values and set the scales accordingly.
This provides the maximum data resolution, but will result in uneven minimum and maximum scale values.
Catalog #91001, 91003, 91004, 91005, 91007, 91009
Rev. 9/06 - RS/mc Page 23 of 47
©2006 Edelbrock Corporation
Brochure #63-0282