Using The Showview Feature - Samsung DVD-R100E Instruction Manual

Using the ShowView
Feature
Before presetting your DVD Recoder:
• Switch on both the television and your DVD Recoder.
• Check that the date and time are correct.
Up to twelve programmes can be preset.
1 Press the ShowView button.
- A message is displayed to allow you to enter the
ShowView code.
DVD-RAM(VR)
Enter ShowView Code number. [0~9]
OK
Using the MENU button.
Press the MENU button when the disc has
stopped.
Press the ...† buttons to select "Programme", and
then press the OK or √ button twice.
2 Press the numeric buttons to enter the
code of the programme that you wish
to record in your television magazine.
If you wish to correct the ShowView code that
you are entering:
Press the œ button until the digit to be corrected
is cleared
Enter the correct digit
44
- English
Programme
RETURN EXIT
Press the OK button.
3
The information concerning the programme is
displayed.
When using the ShowView function for the
first time with stored stations, the programme
number flashes. This one time, you must enter
the PR number manually by pressing the
†... buttons.
DVD-RAM(VR)
Remaining Recording Time 02:12 SP
No. Source Date Start
No. 01
01 CH 09 11/22 09:22AM
Source PR 01 Date
Start 12 : 00 End
Type Once Mode SP
V/P Off
MOVE OK
DVD-RAM(VR)
Remaining Recording Time 02:12 SP
No. Source Date Start
01 PR 01 01/ 01 12:00 14:00
02 -- -- --- -- --:-- --:--
MOVE OK
4 If the programme and times are correct,
press the OK button.
5 Turn the power off by pressing the
STANDBY/ON button to activate the
Timer Recoding setting.
Refer to page 41~43 if you wish to:
6
Check whether the timer Recording has set
correctly or not.
Cancel a preset recording
The numbers next to each TV programme
listing in the magazines or newspapers
NOTE
are ShowView code numbers, which allow
you to programme your
videorecorder instantly with the remote
control. Enter the ShowView code for the
programme you wish to record.
ShowView is a trademark of Gemstar
Development Corporation. The ShowView
system is manufactured under licence
from Gemstar Development Corporation.
Scheduled Record List
End Type Mode V/P Edit
10:30AM Once SP
√ √
01 JAN
14 : 00
RETURN EXIT
Scheduled Record List
End Type Mode V/P Edit
Once SP Off
√ √
-- -- --
√ √
RETURN EXIT