Restore Factory Settings; Information; System Software - Philips DTR500/05 User Manual

NOTICE DTR 500.qxd
28 CHANGE THE SETTINGS OF YOUR RECEIVER
7/09/2004 15:25 Page 28
The selection is on RF channel.
- Press
- Scroll up or down the list to the RF channel you want to select.
- Press <OK> to view the signal quality and strength for the
selected channel.
- If need be, move your antenna to obtain an adequate
signal.When the signal is good enough, the name of the
corresponding network is displayed.
- Press
and proceed as described above to check the signal quality
and strength for another RF channel.
Note: if you cannot obtain an adequate signal, refer to the
troubleshooting guide.
- Press
u
sub-menu, or press the blue colour button to exit the menu.
7.3.4
To restore the receiver factory settings:
- Press <OK>.You are then prompted to enter your master
PIN code.
- Enter the master PIN code. For more information on the
master PIN code, refer to the troubleshooting guide.
Note: when restoring the factory settings, you lose all your
favourite list settings.
7.4
- Press the

System software

This item is used to manage software updates, which are
necessary to keep your receiver up-to-date with the
developments in digital television and make new features
available. Updates are part of normal transmissions.
Your receiver is originally set up to automatically accept
software updates (recommended). If you want to be
prompted each time new software is available, follow the
instructions below.
- Press the
The current hardware/software version is displayed, and the
selection is on Always accept new software.
to access the list of RF channels.
i
again to return the list of available RF channels
i
to exit the screen and return to the Service lists

Restore factory settings

Information

button to access the System software sub-menu.
i
button to access the System software settings.
i