Advanced Settings; Changing The Remote Control Setting; More About Recording; Connecting For Prepare Record Or Record Link - Philips DTR500/05 User Manual

Digital terrestrial receiver
Table of Contents

Advertisement

NOTICE DTR 500.qxd
9

Advanced settings

9.1

Changing the remote control setting

If you have other items of equipment in your home and the remote control of the Philips receiver
interferes with them, you can change the setting of the remote control. For this you must change the
setting of both your receiver and remote control.
To change the setting of your receiver:
Refer to paragraph 7.2.3.5.
To change the setting of your remote control:
- Press number buttons 1 and 3 simultaneously and hold them for at least 3 seconds
- Release the two buttons simultaneously.
- Enter the new setting according to remote control setting value set for your receiver within the
next 60 seconds:
• 4 for alternative setting (38)
• 3 for the default factory setting (39)
Note: if the batteries are removed while a button is being pressed, the default setting (39) is restored.
9.2

More about recording

9.2.1

Connecting for Prepare Record or Record Link

This connection allows automatic recording without the necessity for programming your VCR. Prior
to deciding on this connection method:
- Consult the user manual of your VCR to check if and how the "Easy Recording" feature is
supported. Most Philips VCR and DVD+RW recorders support one of the two Easy recording
options.
- Verify that both your TV and VCR have two SCART sockets.
Incorporate your receiver in your existing installation:
- Plug your aerial lead plug into the "AERIAL IN" socket of your digital receiver.
- Connect the "RF OUT" socket of your digital receiver to the "ANT IN" socket of your VCR by
means of the RF coaxial lead supplied with your digital receiver.
- Connect the "ANT OUT" socket of your VCR to the aerial input socket of your TV by means of a
RF coaxial lead.
- Connect the "TV" SCART socket of your digital receiver to the "EXT1" SCART socket of your TV
by means of the SCART lead supplied with your digital receiver.
- Connect the "VCR" SCART socket of your digital receiver to the "EXT2" SCART socket of your
VCR (sometimes called "IN") by means of a SCART lead.
- Connect the "EXT1" SCART socket of your VCR (sometimes called "OUT") to the "EXT2"
SCART socket of your TV by means of a SCART lead.
- Plug all your equipment, except your digital receiver, into the mains.
- Switch on your TV and select a channel.
- Plug your digital receiver into the mains.Your digital receiver will display the WELCOME screen.
34 ADVANCED SETTINGS
7/09/2004
15:25
Page 34

Advertisement

Table of Contents
loading

Table of Contents