Table of Contents
Advertisement
Active Arming / Locking:
Press button #1 (Lock symbol) on the transmitter. The System will
arm and confirm with one siren chirp, one light flash, and the LED
will begin to flash. Power locks will lock (if equipped). Starter
disable circuit will turn on. After a short delay to allow the vehicle
and electronics to settle, the system will be completely armed.
Disarming: / Unlocking
Press button #2 (Unlock symbol) on the transmitter. System will
disarm and confirm with two siren chirps, two light flashes, and the
LED will turn off. Power locks will Unlock and Interior Dome light will
turn on (if installed with these optional features)
Disarming While Tripped (Triggered):
Disarming the System while it is triggering requires TWO presses of the #2 Unlock Button. The first press of
Button #2 Resets the alarm cycle only (system still armed) while a second press will disarm/unlock the system.
Silent Arming/Disarming:
To Arm or Disarm the system without siren chirps, press and release both Buttons #2 (Unlock) and #4 (Start)
at the same time. System will Arm or Disarm without siren chirps. Flashing lights and LED will be the only
indicators of Arm/Disarm status. If the system was tripped while you were way, 4 chirps will be heard to notify
you that the system was tripped.
Alarm Triggering
An intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for 1 minute.
After 1 minute the trigger cycle will automatically stop and alarm will remain armed to continue protecting the
vehicle. If a door is left open after an intrusion then the unit will cycle a maximum of 5 minutes and continue to
protect the other un-tampered or unopened zones.
Prior intrusion Alert
This system will notify you if the alarm was tripped while you where away. Upon disarming, the two normal
disarm chirps will be heard then the system will emit 4 additional siren chirps. Check your vehicle for any
signs of a break in or tampering. Also see LED Diagnostics Section to determine the cause of the trigger.
Remote Panic Protection
To sound the alarm in an emergency situation or to draw attention to your vehicle, press and hold Button #1
(Lock) for at least 3 seconds until the siren sounds. Press Button #2 (Unlock) to reset panic mode.
OPERATING INSTRUCTIONS - ALARM
#1
ARM/
LOCK
#3
START
TRUNK
CS-2011RS TRANSMITTER BUTTONS
#2
DISARM
UNLOCK
#5
CAR 1-2
#4
REMOTE
START
Advertisement
Table of Contents
