Using Cd Source Controls; Setting Direct Access To A Specific Disc Or Track - AMX DAS-MI-0404 Operation/Reference Manual

Source Controls

Using CD Source Controls

The Audio Source Controls enable you to control a CD Player source to select a specific CD and track.
After selecting a CD and track, the audio plays in the selected room.
FIG. 9 CD Source Control
1. Click the room.
2. Click the CD Player source tab.
3. Click the UP / DOWN button to access the next/previous Track.
4. Click the LEFT / RIGHT button to access the next/previous CD.
5. The ROUND button may/may not be defined, check with your installer.
6. The SQUARE button may/may not be defined, check with your installer.

Setting Direct Access to a Specific DISC or TRACK

1. To select a specific CD and track, using the number buttons, key in the CD #, press the DOT button,
key in the track # and press ENTER (Ex. 25.4Enter = CD 25, Track 4).
2. To select a specific Track on the current CD, key in the Track # and press ENTER (Ex.4Enter =
Current CD, Track 4)
If a CD and track number are selected and the Enter button is not clicked, the CD
player will remain on the current CD and track.
All source control buttons are defined at the Mi-Series Controller at the time of
installation and may perform differently than described below. Please verify the
functionality of the source control buttons with your Installer.
The ROUND and SQUARE source control buttons may or may not be defined.
Please check with your installer.
14 Mi-Control Mi-Series Configuration Software